Search results

  1. A

    Horn issue

    Ive already swapped out the horn relay. And the horns are just factory used horns which worked fine when I first put em on. IF you could post the diagram I'll check it anyway just to be safe. I think I know what may have caused this issue after looking around the car today. When I bought...
  2. A

    Horn issue

    Does anyone have any pics or diagrams of said multiplex?
  3. A

    Horn issue

    So after reading some more about the multiplex I found out that the horn and the dash lights dont work. So I decided to check my dash lights and low and behold they dont work. So is this a deff multiplex problem or is there something else that could cause this? All in all tho im gonna have to...
  4. A

    99 front wheel bearings?

    Ahh, good point on the weight transfer, never thought of that, lol.
  5. A

    99 front wheel bearings?

    its prob the pass side. But if one is going the other is prob not far behind.
  6. A

    Horn issue

    Actually I did pull out and check every fuse, I checked all in the fuse box under the hood, all in the fuse panel on the pass side and all in the driver side panel. Unless there is another panel im missing im pretty sure none were blown.
  7. A

    Horn issue

    So I recently installed new horns in the front of the car, just stock replacements due to old ones dieing. Once we hooked them up they worked fine. Once I drove home they stopped working. I noticed before I put the new horns in that when I push on the steering wheel you can hear the relay...
  8. A

    *Slammed Thread* (56k)

    Mmmm CB9 FTW! Very clean
  9. A

    *Slammed Thread* (56k)

  10. A

    Loss of power

    Just did some reading around and from what I see its the distributor that has the sensors in it? So it could be a loose connection somewhere or a bad distributor? Anyone else throw this code?
  11. A

    Loss of power

    So I checked the CEL and it flashed 9 times, all quick blinks, no slow, just repeats the set of 9 flashes. Not sure if I looked it up correctly but is it the Cylinder Position Sensor? 9 P1381 Cylinder Position Sensor Intermittent Interruption 9 P1382 Cylinder Position Sensor No Signal
  12. A

    Loss of power

    I'll go check again in the morning and post it up.
  13. A

    Loss of power

    98 LX Sedan 5 Speed When I have it in neutral and rev the RPMs up they fall really low almost stalling the car. Also when im going up a hill or give it gas in the low RPM range it has no power and is kind of sputtering. Engine code was something along the lines of the distributor if i...
  14. A

    Issue removing alternator

    We actually had to slide it all the way forward and then remove the bracket holding the alternator on. Had to hammer rout the adjustment bolt, lol. Lots of rust. On my way to Honda to get a new set. Thanks for the help guys!
  15. A

    Issue removing alternator

    2/3 bolts are out and the nut is off, im just having trouble sliding the top A bolt on the picture out. The nut is off the end of it and the longer bolt is out of the bottom, but this top A bolt wont budge. Its a bit rusted too. I sprayed WD40 on it awhile ago but still not moving.
  16. A

    Issue removing alternator

    ^ Thanks, I know what to remove, but im having trouble getting the adjusting bolt out, it wont just slide out after I take the nut and other(Lower in picture) adjusting bolt out.... any suggestions?
  17. A

    Issue removing alternator

    Ok so its #5 im having the issue with. http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=ACCORD&catcgry2=1998&catcgry3=4DR+LX&catcgry4=KA5MT&catcgry5=ALTERNATOR+BRACKET I assume this has to be removed for the Alt to come out. If its suppose to come out how...
  18. A

    Issue removing alternator

    Sorry, its a 4cyl, and I dont think the fan is in the way of anything.
  19. A

    Issue removing alternator

    Ok, so I need to replace my alternator and im in the process of removing it. My issue is with actually getting it out. I removed the long bolt at the top, the nut on the right side, and the long tentioning bolt on the bottom front. According to the info I found all I have to do now is wiggle...
  20. A

    what dimensions is the front 01-02 coupe badge

    part number 75700-S84-A11 http://www.hondapartsnow.com/genuine/honda~emblem~75700-S84-A11.html
  21. A

    Horn Issue..

    So long story short, i had to get new horns for the car because the old ones has the connectors broke off the backs of them. Installed the new horns and they worked great. Only thing that changed in between when they worked and stopped working was we had the SRS cover over the lower steering...
  22. A

    DIY: Rear Wheel Bearing Replacement

    Great write up, hope i dont have to do this any time soon, lol. Repped..
  23. A

    front end rebulid? parts list

    dont foget about a splash guard lol, looks like yours got ripped off
  24. A

    Ferron's 2001 accord sedan ex 4cyl

    i think the chrome trim goes nice with the chrome lip on the rims. Car looks good dude!
  25. A

    front end rebulid? parts list

    lol good luck with the project, looks like you need quite a bit. Subframe is prob bent too.

Latest posts

Random media

Yeah my car used to look like that lol
New hood Bra
2467.jpg
Roof Rack in Use
MMMMMMMM
Back
Top