nabwong
Well-Known Member
My oem low-beam blew so I replaced them with some Philips 9012. YAY!
What'd you do to your accord today?
- Thread starter HondaLuver83
- Start date
Narftastic
Well-Known Member
Scraped frame like a BOSS!!!!
Finally got around to fixing the led in my cruise control button, replaced my old pa toggle switch with the switch blank, removed all extra speaker wire that was run for the pa, and also removed the remote wire that used to go to my amp. Haven't gotten around to the ground, positive, and rca wires yet though. 
Also installed tow hook.
Also installed tow hook.
I lowered the car more today... but drove it for about 5 minutes and it kept hitting my fender well in the front do to my winter wheels with the fatty tires. So raised it just a little and it looks perfect. Can't wait to get my XXR rims back on!
here is a pic of how low I went
Did you by any chance measure from the floor to the top of the fender?? Curious as too how low that is
JordanFleenor
Well-Known Member
Scraped frame like a BOSS!!!!
Throwin sparks? ... LIKE A BOSS
Naw I didn't. I can measure what it is tomorrow and let you know.
LeBirdNest
Titleist
i washed my car today and it was much needed.
accordrocca
Well-Known Member
Washed my car n snapped sum pics
got the sickest sticker
Ull see it on my members ride thread ill prolly post tomorrow
got the sickest sticker
Ull see it on my members ride thread ill prolly post tomorrow
SykVSyx
Well-Known Member
On Tues, the wife's TL decided that the driver's side LBJ would snap, pull the drive shaft out all while she and the baby were on the highway.
Yeah.....NOT a good day.
Will find out today the extent of the damage/cost.
Yeah.....NOT a good day.
Will find out today the extent of the damage/cost.
RedRyder
Save the manuals
^Damn Derek, relieved everyone is okay. Were there any warning signs the joint was going bad?
Replacing my tie rod ends Friday, maybe I should look into how much extra it would be to to do the lower ball joint...
Replacing my tie rod ends Friday, maybe I should look into how much extra it would be to to do the lower ball joint...
SykVSyx
Well-Known Member
No, we just did all the brake pads, and the mechanic never mentioned anything.
Also have to replace the end links for the RSB. Not as urgent, but will probably just do it all at once.
I didn't take a pic, but the tire is facing 90 degrees to the left, it pushed the fender a bit too, so not sure about the extent of the damage of the fender.
Also have to replace the end links for the RSB. Not as urgent, but will probably just do it all at once.
I didn't take a pic, but the tire is facing 90 degrees to the left, it pushed the fender a bit too, so not sure about the extent of the damage of the fender.
