Sleeper Cell
No more CG Squad!!!
Crazy ≠ Good. 12mm more poke than on my car would look like you're trying too hard in my opinion.
Wheel Fitment Thread
- Thread starter xci.ed6
- Start date
kn0x47
Senior Member
^when does everyone get to see your new setup
or are you actually rocking the ones you got from the company you work for?
or are you actually rocking the ones you got from the company you work for?
Sleeper Cell
No more CG Squad!!!
They're not VMRs, but I'll probably pick up a set eventually. I will say that they are multipiece wheels and nobody has a setup like it quite yet. The wheels should be getting finished up this week. I should have them by the end of the week or possibly the beginning of next week.
truWarier02
Well-Known Member
Can't wait.
shenaniganz08
Well-Known Member
my car's been recently waxed and is relatively low (not slammed) if you wanna take some pics these next couple days 
Edward93
Active Member
15x8 +20
both look good imo
Thats my friend smiley. I bought those wheels from him and had them on my jdm h23 swapped cd5 accord. I bought those wheels from him.. they were 15x8 +15. Tires were 195/50/15.
Last edited:
RotaryRx7
New Member
Hey guys, I have a completely stock 2002 Accord V6 sedan on the stock 15" alloys and just purchased a set of 2008 MazdaSpeed 3 rims for it. I would like these to fit without making any modifications to the car. Is this possible? The MazdaSpeed wheel specs are 5x114.3, 18x8, with an offset of +52.5.
What tire size would work best? I currently have a set of 235/40/18 sitting in my garage but I think these may be too big. I can deal with minor rubbing but would like to avoid doing serious damage to the car or tires.
Any help would be greatly appreciated.
What tire size would work best? I currently have a set of 235/40/18 sitting in my garage but I think these may be too big. I can deal with minor rubbing but would like to avoid doing serious damage to the car or tires.
Any help would be greatly appreciated.
Narftastic
Well-Known Member
since your not lowered they should fit fine, but they will be pretty sunk in.
RotaryRx7
New Member
Thanks for the response.
Will the tire size I mentioned work well for both front and back? Should I add spacers to bring them out a bit? What size spacers?
Narftastic
Well-Known Member
yea tire size looks rite, as far as spacers go i would put the wheels on first then see how big spacers u need
