Hello Everyone, Been off the forum for a while now and am slowly getting back into the 6th gens. As some of you may remember i started a g23 build and then disappeared(like most g23 builds). haha. Anyway the build was very time consuming and draining on my pockets and eventually got put on hold...
He basically covered it. Im running an HA motorsports chipped p28 with neptune tuning software. My tuner uses a NEPTUNE RTP to tune then burns a chip which goes in the car at the end. I dont have emissions where i live so thats not a concern of mine. haha U can also run an AEM obdii computer...
thats interesting cause im sure it has to be the same mount. Im tempted to take the mount to a junkyard just to make sure my car isnt the issue. i just dont know how it could be. they have sent me two mounts now and both do not fit.
I recently ordered some innovative motor mounts, The driver side mount doesnt line up, ive talked to innovative. They sent me a replacement with same issue. Has anyone else had this problem only 2 out of the 3 holes line up. Im calling them back today and was hoping that someone else had the...
Re: Greekpizzas G23 turbo build (UPDATED:12/2/2013)
Update: Precision 6262 is in the mail, innovative mounts are in. waiting on a small piece from my buddy Akoutmous then the engine will be going in the car and ill post some pics. Also sent my EPROM chip off to Matt Shue for a basemap to start...
dont do a head swap. trust me im building a g23 right now. so much work. Like everyone else said search. My build thread is in my sig. Your cheapest and best way out is turbo the f23. still looking at 2-3k. Good luck!
Good buddy of mine is trying to sell some wheels.
two sets of Acura TL wheels,(17x8) in good shape have a few small chips. He got them from a dealership who decided to put aftermarket wheels on all TL's in the lot to try and move them a little quicker so they are in good shape (400each...
Hmm interesting mine threw this code as well but allowed me to rev through the range. I tried swapping it and i think the code just came back up. I think i narrowed it down to an issue with the cam sensor in the distributor. did you have the car tuned? If your using the oem distributor on obd1...
this build cost me about 3-4k with exhaust and tuning. Your biggest expenses to account for would be custom exhaust. Your ECU which can differ depending which route you take. Im running a chipped p28 tuned on NEPTUNE, to do this you have to convert the car to obd1. Your turbo and wastegate are...