DIY - Morimoto Mini H1 projectors Retrofit

[kangarooster]

Would those projectors fit into the high beam bucket as well? Or are they too big for it?

 

[dharding413]

They should.

http://www.6thgenaccord.com/forums/showthread.php?t=40635&highlight=quad+projector

 

[blackcord]

^ I am pretty sure that she had to hack the back of her highbeam bucket to get the Morimoto to fit. Check out the 7th. picture from the top.

 

[lashlee]

Like someone else noted I think you would have to hack up back of the bezel to get it to fit. Mine shrouds touch the lens as it is, I would hate to think how much has to be cut to get them to fit in the high beam bucket.

In my opinion I think the mini's are awesome in the low beam spot wired up to work as a bi-xenon. I think they have all kinds of output.

 

[kangarooster]

Oh well. A little work goes a long way right? I'm going to have to try this out. Thanks!

 

[SportBilly]

Very nice presentation.. And u use the 9006 bulb??

 

[001Stunna]

Very nice presentation.. And u use the 9006 bulb??

It's called Morimoto Mini H1....Not...Morimoto Mini 9006.

 

[Anth]

Sorry for the bump!

But good job on the lights!

Ive been thinking about doing the same this summer on mine but

Which shrouds would fit? Mini Gatling gun or mini graphite?


Thanks!

 

[001Stunna]

Sorry for the bump!

But good job on the lights!

Ive been thinking about doing the same this summer on mine but

Which shrouds would fit? Mini Gatling gun or mini graphite?


Thanks!

Go to
www.theretrofitsource.com

PS. the fact that both shrouds you mentioned are called "mini" should tell one that they both fit the "mini" h1 projectors.

 

[phi1542]

Will the mini gatling shroud fit without trimming since its smaller than regular shrouds? And can I use these with DDM Tuning H1 HID kit?