H22 Question?

[5thGenAccord]

So far you have shown me one graph with 177.7 hp and Jackhunt on boost making 400hp. So where is there any hard documentation that shows the f making more power then the h???? Atleast give me some respectable dyno graph of a f23 making 250hp N/A.

How can you say 2point6 doesn't count???? He used this engine in his DD. Don't get frustrated that no one has document what the F can and can't do as well as 2point6 has with the h. I'm thankful that he has shown me what my H22 is capable of. Besides he says many times that his engine can be duplicated.

 

[BlkCurrantKord]

If thats the way you wanna go, I could take the F22 from Bisi's drag Insight and put in a 4thgen accord and call it my DD, all it needs are plates and insurance.

Did I not just say I was still looking? Show me an H22 that hasn't sleeved his block and is making 250whp N/A.

2point6 doesn't count b/c his setup can't be duplicated over and over and over and although he claims it as his DD, I highly doubt its that daily driven. I thought we were talking street cars, that guy has well over $10k in just the motor, not including the cost of the motor.

 

[5thGenAccord]

If thats the way you wanna go, I could take the F22 from Bisi's drag Insight and put in a 4thgen accord and call it my DD, all it needs are plates and insurance.

Do IT!!!!!!!!!!!


Oh and so you don't think I'm leaving F/I out here is Booja's dyno sheet. He says he is making 504whp but I can't find the graph for that so I will just say he is making 491 whp.

Holy this graph is huge here is a link instead http://www.hondasociety.com/board/showthread.php?t=113915

 

[5thGenAccord]

Show me an H22 that hasn't sleeved his block and is making 250whp N/A.

This is it http://www.junauto.co.jp/democar/prelude/spec.html?en

 

[BlkCurrantKord]

This is it http://www.junauto.co.jp/democar/prelude/spec.html?en

Not DD and most likely sleeved. You fail.

 

[5thGenAccord]

Not DD and most likely sleeved. You fail.

NOT SLEEVED!!!!!!!!!!! Cosworth makes the pistons for JUN and from what I have heard are compatible with FRM. If you read closely it uses a standard bore. Its atleast a street car, full interior and A/C.

 

[BlkCurrantKord]

Its a shop car, not a street car. Standard bore doesnt mean anything. You can have any motor sleeved to standard bore.

 

[Egi7]

Boy, yall have just dragged this thing to the mud and back.............lol

 

[BlkCurrantKord]

Boy, yall have just dragged this thing to the mud and back.............lol

We're not done yet.

 

[5thGenAccord]

We're not done yet.

WORD!

Besides we have to have something to do, I like friendly debates.

We should have one of these all the time. You can learn alot in a matter of minutes just from our posts and links. We do all the work for you in the quest of being right.