Recent content by b18lsturbo

  1. b18lsturbo

    h22 dizzy wiring

    yes check out one of those link on page one of this thread,
  2. b18lsturbo

    h22 dizzy wiring

    nice but mines is obd1.some stuff tho cause ur left with the blue one.i fired it up today and man it sounds like it got balls!!!! iab is working nice and my iavc is working perfect no up or down on idle.i still didnt get to drive it yet cause its in the body shop and i just turned it on and...
  3. b18lsturbo

    h22 dizzy wiring

    back to the wiring now to the cyp wires 1.connect the yellow wire to the orange one from the h22 plug 2.connect the black wire to the white one from the h22 plug thats take care of the cyp now u have 3 wires left over 2 of them go to the same colors wires but the fat black/yellow wire need...
  4. b18lsturbo

    h22 iavc wiring

    check the dizzy thread i almost done with it just 4 wires left and 2 of them are for the cyp
  5. b18lsturbo

    h22 iab wiring

    doing the h22 swap and u want to use the the iab or the butterflys then ur going to have to wire it in the the harness.now back to the h22 harness cut off the iab plug from the harness.always cut long to shorten later if needed. u will notice that it has 2 wires one is black/yellow wire and the...
  6. b18lsturbo

    h22 iavc wiring

    ok if ur like me and every one else that have a 6g accord.then ur stock iavc plug has 3pins in it and the stock h22 has 2 pins.now cut the h22 harness again and cut the iavc plug off.now do the same to the f23.remember the f23 isvc is located in the back of the intake and the h22 in front.so...
  7. b18lsturbo

    h22 dizzy wiring

    if u did what i said earlier with the plug by the crank that u cut and have 4 wires to the colors u should have is green,red,blue and white those are the 4 colors of wires for the tdc and ckp. 1.now connect the green wire to the orange/blue wire from the h22 dizzy 2.now connect the red wire to...
  8. b18lsturbo

    h22 dizzy wiring

    if u use a p28 make sure they add the iab chipset and tuned to use it.ur going to want it.and my obd2 to obd1 harness is labeled not from ebay.cost was 59us dollars.give me a sec the body shop guy is here to take the car and put the front and rear lips and lights all around and prep to...
  9. b18lsturbo

    h22 dizzy wiring

    but if ur like me and is going to use a p72 tuned with a obd2b to obd1 harness plug.why p72 cause i want to keep my iab working.on the tuning side im going to turn off some stuff like sensors in the ecu that makes my first crank easy.like Speed governor removed Knock sensor removed Vtec...
  10. b18lsturbo

    h22 dizzy wiring

    plugs to cut from h22 harness cut the wires long for u to shorten them later 1.ignition wires plug 2.coil wiring yes ur see way later not from the plug tho. 3.iab plug yes cause this wire has to be ran to the ecu by itself 4.idle air control valve plug why cause f23 is in the back of its...
  11. b18lsturbo

    h22 dizzy wiring

    today i open both dizzy to find out how the ignition module is wired up.I found out that the stock internal coil is jumped off the 1 spark wire on the stock f23 ignition module. and the h22 has the its coil wired by 2 wires going to the ignition module and one back up.so cause the plug on the...
  12. b18lsturbo

    Possible knock

    sounds really bad like a rod lose.if it take a crap on u save um and go h22.not f20b why cause u need toque for the heavy body
  13. b18lsturbo

    99CcordMTF23's H22-Swap thread! Update, 10/26/12, pics pg6! RUNNING!

    Re: 99CcordMTF23's H22-Swap thread! Update, 6/6/12, pics pg2! i dropped my swap in with everything on it and i used every thing from the f23 but power steering is from prelude
  14. b18lsturbo

    00 sedan major power loss going up mountain FLASHING CEL

    nope had that happen to me before check the timing side for something brokin and sounds like u lost oil pressure when it broke and low pressure mean lost in power by alot i know from exp. on the freeway home from work
  15. b18lsturbo

    vtec solenoid valve

    make sure its that part before u buy it theres no return on that item!!! 1. check ecu 2.check sensors plugs 3.vtech opens with oil pressure check it too 4.ur in limp mode 5.check coole many people have this problum too when the ecu doest see the temp.
Back
Top